Revamp Your WiFi Experience With Netgear Extender Setup

Author : michaelkeller909
Publish Date : 2020-09-12 11:16:06


Netgear extenders are the top-grade WiFi devices to get fast WiFi everywhere in the home. Big homes often need superior extenders for having instant WiFi access in each and every room. In this post, we've pulled together the ways through which you can perform the Netgear extender setup without any hassle and amplify your existing network.

How to Set Up Netgear Range Extender?

After the Netgear extender configuration process, you will not only enjoy lag-free internet but also turn your dead zones into fun zones.

There are several ways to install a Netgear extender. You can either employ the Netgear Installation Assistant or opt for the WPS method to make your device up and running. Let's discuss both the methods of Netgear extender setup one by one.

Set up Netgear Extender via Netgear Installation Assistant

It is the most preferred method employed by users for the successful extender configuration. Here's how to set up Netgear extender using the installation assistant:

  • Unpack your WiFi extender and connect the antennas available.

  • Now, establish a wired connection between your Netgear extender and router.

  • Keep in mind to place your extender and the existing WiFi router in the same room.

Bonus Tip: Users can connect both the devices either via an Ethernet cable or wirelessly. However, it is recommended that set up a connection between devices using a non-damaged cable to prevent any setup-related problems.

  • Thereafter, turn on your extender by plugging it into an electrical socket.

  • Via a laptop or PC, access www.mywifiext.net by entering the URL into the address bar of your web browser.

  • The Netgear extender login window shows.

  • Here, you are required to type the default user ID and passphrase of your Netgear extender.

  • After entering the requested credentials, hit Log In.

  • You will now see the Netgear genie setup wizard.

  • Post that, check the list of WiFi networks available and pick the one you yearn to amplify via the range extender.

  • Next, walk through the on-screen steps until you complete the Netgear WiFi range extender setup process.

  • After finishing the installation, connect your WiFi-enabled devices to the extended network and start accessing the internet in accordance with your requirements.

This was all about installing a Netgear extender using the Manual Method.

Note: On the off chance if the Netgear default web address displays an error pop-up rather than taking you to the WiFi extender login page, utilize the IP 192.168.1.250 IP to reach there.

Set up Netgear Extender via WPS Method

Found the manual setup method a bit tricky for you? We have got you covered! This post also covers another method to set up and install your Netgear wireless range extender. And that method is WPS. Here's how to use WPS push button to set up your Netgear range extender:

  • To get started with the Netgear WiFi extender installation process, put your extender on power and be certain that the device is getting adequate power supply.

  • Assure that the extender is placed in the same room as that of your router.

  • Now, find out the WPS button on your range extender.

  • Once located, press and hold the button.

  • Thereafter, press the WPS button present on your router.

  • Wait until you see all four green LEDs on your extender.

In this way, one can use the WPS method for Netgear wireless extender setup.

We hope that both the Netgear extender setup methods work flawlessly for you. Do remember to share your experience about whether you find the setup process simple or quite challenging for you in the comments section below.

However, if you are still experiencing any sort of technical issues while installing your Netgear WiFi range extender, then make sure to contact our highly-knowledgeable experts.



Catagory :general