Netgear WiFi range extender is a renowned device for extending the wireless signals incoming from the existing router. In case you own a huge house or enormous workplace then the router alone is not enough to cover the whole area with the fast internet.
As a result, users are unable to access the WiFi all over the home or office. The areas where you don’t have WiFi connectivity are dubbed dead spots. The best way to eliminate this annoying problem is Netgear extender setup.
For the Netgear extender installation and setup, there’s a need to access mywifiext.net To do so, just open an updated browser on a computer and browse into the Netgear extender login page.
Once logged in, it is pretty simple to install and set up your Netgear extender with no hassle. However, the extender needs to be connected to the primary router with the help of an Ethernet cable.
How to Perform Netgear Extender Setup?
There are two ways to perform the Netgear WiFi range extender. They are:
Via the WPS Button
1. Using Mywifiex
Walk through the instructions mentioned underneath to set up your Netgear wireless extender via mywifiext:
Take the power adapter and connect its one end to the extender while another to the wall socket.
Check the Power LED on your Netgear extender to ensure that it is turned on.
Establish a wired connection between your Netgear range extender and the existing router via an Ethernet cable.
Make sure that your router is also powered on.
Now, on your computer or laptop, open your preferred web browser.
In the address bar, type www.mywifiext.net
Pressing the Enter key will take you to the Netgear extender login web page.
Enter the user ID and security key into the prompted fields.
Click on the Log In button.
After logging in, you will see the Netgear genie setup wizard.
Select the WiFi network you yearn for extending.
Enter the network password when prompted.
Hit the Continue button.
Set up security settings for your new WiFi network created by Netgear range extender.
At last, click on the Finish button.
Now, you will be presented by a page that says 'Congratulations! Your Netgear extender has been set up'. Afterward, connect all your WiFi-compatible devices to the new extended network.
2. Via the WPS Button
Another method to perform the new Netgear extender setup is to use the WPS button. Here are the necessary steps to complete your new extender setup using the WPS method:
Power on your Netgear WiFi range extender and check the status of power LED on it.
Turn on your home WiFi router as well.
Press the WPS button on your extender.
After that, push the WPS button on your router.
Wait until the WPS LED turns on.
That's all! You are all done with the Netgear WiFi range extender via the WPS button. Now, connect all your wireless devices to the new, extended WiFi network and enjoy an extended wireless range and speed.
- Instructing a youngster to examine can be an actually difficult prospect - on the very little a single,When you are home education your son or daughter
- What could potentially be further elementary than studying?What increased reward could you as getting a father or mother give to your
- There are a lot of things to remember before you hire a web development and web design firm.
- With the internet becoming place. about the new deal that contained a provision that seniority by on your own would not decide trainer assignments or transfers.